NT-1228BC Barcode Scanner Wireless General Settings

1、Get Firmware Version

2、Operating Mode

Normal Mode
Store Mode
Memory Data Upload
Get Memory Barcode Number (Total Count)
Clear Memory After Upload
Check Memory Usage
Clear Memory Barcodes
Auto Store Mode Off
Auto Store Mode On

NOTE 1: During data upload, scanning "Memory Data Upload" again will cancel/stop the upload.

NOTE 2: In wireless transmission mode, if auto store mode is enabled and a wireless 2.4G transmission fails, the barcode will be automatically stored and can be retrieved by scanning "Memory Data Upload."

3、Power Management

① Sleep Time Read

② Set Sleep Time

Power Off: Immediate Sleep
Sleep Time = 1 min
Sleep Time = 3 min
Sleep Time = 5 min
Sleep Time = 10 min
Sleep Time = 30 min
Sleep Time = 1 hour
Sleep Time = 2 hours
Never Sleep

③ Get Scanner Battery Level

4、Decode Time

① Decode Timeout

• This parameter sets the maximum time for decoding attempts during scanning. Default: 3000ms, Range: 0500-9999ms.

② Decode Interval

• Interval time between scans in Continuous Mode. Default: 500ms, Range: 0100-9999ms.

5、Information Prompt

① Beep Control

Note: Not all barcode scanners have the "Base Connect Beep Prompt" or "SDK" function.

② Vibration Control

Note: The vibration motor works when the beep sounds. Not all barcode scanners have this function.

③ Sound Prompt

④ LED Indicators