M5 Barcode Scanner Wireless General Settings

Wireless Barcode Scanner General Settings # #

1、Get Firmware Version # #

                  Get Version Number

2、Factory Reset # #

               Restore Factory Settings

Write to Custom Defaults

              Restore Custom Defaults

3、Operating Mode # 

NOTE 1: During data upload, scanning "Memory Data Upload" again will cancel/stop the upload.

NOTE 2: In wireless transmission mode, if auto store mode is enabled and a wireless 2.4G transmission fails, the barcode will be automatically stored and can be retrieved by scanning "Memory Data Upload."

4、Power Management # #

① Sleep Time Read

                   Read Sleep Time

② Set Sleep Time

Power Off: Immediate Sleep
Sleep Time = 1 min
Sleep Time = 3 min
Sleep Time = 5 min
Sleep Time = 10 min
Sleep Time = 30 min
Sleep Time = 1 hour
Sleep Time = 2 hours
Never Sleep

③ Get Scanner Battery Level

             Get Battery Rough Level

5、RTC Clock Settings # #

• NOTE: Applicable only to scanners that support RTC.

• Set the time by scanning the following format: “yy/mm/dd, hh:mm

  ” (includes time zone, so the local time is displayed). Example: %RTCTIME#23/05/26,16:21:40. Alternatively, synchronize time via Bluetooth SDK.

               Disable Time Stamp*

Enable Time Stamp

6、Scan Modes # #

Barcode Decoder Scan Mode*

             Key Scan Mode (Default)

Continuous Scan Mode

Note: Continuous scan mode is ideal for rapid scanning, such as in a courier scenario. Trigger the scan by pressing the Trigger button to start or stop scanning.

             Key Pulse Scan Mode

Note: Scanning begins when a button press is detected (maintained for approximately 30ms) and ends when another button press is detected. Scanning stops upon successful decoding or timeout.

Host Trigger Mode

7、Decode Time # #

①Decode Timeout

• This parameter sets the maximum time for decoding attempts during scanning. Default: 3000ms, Range: 0500-9999ms.

                        3s (Default)

6s

②Decode Interval

• Interval time between scans in Continuous Mode. Default: 500ms, Range: 0100-9999ms.

                      0.5s (Default)

1s

8、Information Prompt # #

① Beep Control

                             Mute

High Volume

                    Medium Volume

Low Volume

                         High Tone

Low Tone

           SDK Sound Response Off

SDK Sound Response On

     Base Connect Beep Prompt On/Off

Note: Not all barcode scanners have the "Base Connect Beep Prompt" or "SDK" function.

② Vibration Control

                             Disable

Enable

Note: The vibration motor works when the beep sounds. Not all barcode scanners have this function.

③Sound Prompt

④LED Indicators